Promag CON-485 Series Instrucciones de operaciones descargar pdf (Pagina 48)

5 Operation / adjusting device settings - Set-up to commissioning Memo-Graph S

48 Endress+Hauser

5.7.4 Products

Here, the settings for 20 different products can be viewed or changed.

Synchronous time Time at which signal analyses are completed. Example of daily analysis: the daily analysis is completed at the set time, i.e.

it contains the analysis of the measured values over the last 24 hours.

Zero reset The analyses are reset with this function (e.g. reset after completing the commissioning of a system)

! Note!

• All previous (commissioning) signals are discarded.

• The graphs/storage are, however, not affected if you leave the set-up and answer the “Accept set up?” question with

“No” (reference).

• If you answer the question with “Yes”, the contents of the memory and thereby the graphic display is also dele-

ted/reset.

• If the previous signals are still required, save them on a diskette to protect them against a reset (see Chapter on “Pro-

cedure in operation - Accessible functions - Diskette”).

• The reset takes effect immediately, if you confirm here with “Accept” (“

↵”).

Set-up -> Signal analysis

Set-up -> Products

Product switches “no”: no relay (open collector) is switched, even when a product is running.

“Relay x ( Term. Xx -xx)”: switches the corresponding relay (or OC output) when a product is running. The terminal

numbers are shown in brackets. For connection instructions, see also “Terminal diagram”.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 97 98

Sin comentarios

Promag CON-485 Series Instrucciones de operaciones Pagina 48