Promag CON-485 Series Instrucciones de operaciones descargar pdf (Pagina 33)

Memo-Graph S 5 Operation / adjusting device settings - Set-up to commissioning

Endress+Hauser 33

Signal settings -> Analogue inputs -> Analogue input x: Profibus DP sub-menu (Option

Listener / Monitor):

Settings only required if the measured values for this channel are to be acquired using the data inter-

face (and not by an analogue input).

Note!

This option can only be seen if the device has been ordered with the “Profibus DP Monitor” option

and has been activated under “Interfaces - Data interface - DP bus monitor”.

Signal settings -> Analogue inputs -> Analogue input x: Profibus DP sub-menu (slave

option):

Note!

This menu is only available if an external Profibus module is connected to the Safety Data Manager.

Before the corresponding analogue input can be set, the “external Profibus-DP slave module” data

interface must be set in the set-up under interfaces.

Set-up -> Signal settings -> Analogue inputs -> Analogue input x -> Profibus DP (Option Listener / Monitor)

Slave address Select the address of the corresponding sensor. Every sensor, “Slave”, must have its own, individual address. The measu-

red value (of the digital bus signal) is treated in the same way as conventional analogue measuring points.

! Note!

If a slave delivers several measurement data sets (“Input Index Data” for multi-parameter sensors), each channel requires

its own channel.

Input_Data index Position where the measured value information in the PROFIBUS transmitter data set begins. For one channel devices:

“000”. Please also refer to the Operating Instructions of the connected sensor.

Data type Mainly “Floating Point”. Please refer to the Operating Instructions of the connected sensor.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 97 98

Sin comentarios

Promag CON-485 Series Instrucciones de operaciones Pagina 33